1.3 ohms according to the manual.  Anyone know where this resistance wire is on the 84 full size?

When I move the key from start to run it dies.  The starter relay is dual pole - so it also sends full 12 volt into a special little circuit to the fuel pump when the key is in start, bypassing this resistance wire.

Maybe this R-wire is toast??  When i disconnect the other little wire from the starter relay and put in 12 from the battery the car runs !!  

I tested out the ignition switch and fuel pump relay and they seem to work.  

Any BTDT?  

I found it.   It's one of the 5 wires that bolts up to the POS side of the starter relay.   Actually  the fuse-link burned up.  

I'll have to buy a new fuse link,  and figure out how to hook up both a resistance wire and regular wire to the fuse link.
steve