Hi,I am looking into doing a rearend swap. I have a 1968 Mustang coupe with an inline 6 cyl with an automatic transmission and has a 7.25 rearend. I am looking into buying and installing an 8 inch rear end from a 1967 Mustang that had a 289 engine that also comes with the drive shaft. I plan to keep the inline 6, will the 8 inch swap over with out any problems?Thanks in AdvanceRaul
hmm... is that a 4 lug car???this is out of my range of knowledge..i know you have been around i looked at your user profile and you only belong to one magazine.. .. are you aware that there are 4 mustang and ford specific and about 30 other car and truck magazines on this site.http://forums.mustangmonthly.com/active-posts/http://forums.mustang50magazine.com/active-posts/http://forums.musclemustangfastfords.com/active-posts/each magazine has tech articles and lots of forum posts to search thru..click on source internet media icon at the bottom of the page. that will take you to a new page.. then click the our sites tab..that will take you to a list of the amazing amount of magazines and sites here..