Posted: 09/19/13 07:53 AM
I am looking into doing a rearend swap. I have a 1968 Mustang coupe with an inline 6 cyl with an automatic transmission and has a 7.25 rearend. I am looking into buying and installing an 8 inch rear end from a 1967 Mustang that had a 289 engine that also comes with the drive shaft. I plan to keep the inline 6, will the 8 inch swap over with out any problems?
Thanks in Advance
Posted: 09/21/13 11:03 PM
hmm... is that a 4 lug car???
this is out of my range of knowledge..
i know you have been around i looked at your user profile and you only belong to one magazine.. .. are you aware that there are 4 mustang and ford specific and about 30 other car and truck magazines on this site.
each magazine has tech articles and lots of forum posts to search thru..
click on source internet media icon at the bottom of the page. that will take you to a new page.. then click the our sites tab..
that will take you to a list of the amazing amount of magazines and sites here..